BRILEX - IndoorVent IV

IndoorVent

BRILEX - IndoorVent IV

Indoor Explosion Venting
By using BRILEX Explosion Vents in combination with a unique BRILEX Ceramic Filter, economical venting of dust explosions is possible. When the vent opens during an explosion, the ceramic filter retains the dust and cools down the hot gases

Development Criterion
Existing quench pipes are uneconomical, not re-usable or have lower venting efficiencies requiring high vessel strength. The BRILEX IndoorVent offers unlimited use with the highest known efficiency.

IndoorVent

BRILEX - IndoorVent IV

Applications
Due to high investigation costs and bad efficiency, design engineers and end users tried to find alternatives. The BRILEX IndoorVent offers a combination of a fast opening BRILEX Explosion Vent with a high efficient ceramic filter. The vent area of the IndoorVent is greater than the vent areas of existing quench pipes. After an explosion the IndoorVent can be re-used. The result is a cost effective solution for plant designers and end users for all industries.

IndoorVent

BRILEX - IndoorVent IV

Parameters
The BRILEX IndoorVent can be used for reduced explosion pressures (P red) between 0.2 to 1.5 bar g and K st values up to 250 bar m/sec.


IndoorVent

BRILEX - IndoorVent IV

After an Explosion
Times have changed since explosion quenching systems had to be thrown into the waste bin after single use. The BRILEX IndoorVent can be re-used after changing the filter cartridges and the explosion vent. Maintenance time of approximately 30 minutes is only needed before it can be used again. BRILEX guarantees this after each dust explosion.

Delivered Products

BRILEX delivers complete units consisting of the IndoorVent and a pre-installed BRILEX explosion vent including integrated flange gaskets and monitoring sensor. A spare parts kit for immediate use after an explosion consisting of explosion vent and filter cartridges.

Technical datas

Type IV 240 IV 600 IV 1000 IV 1600 IV 2200 IV 3200 IV 4200
Flange DN 200 DN 300 DN 400 DN 500 DN 600 DN 700 DN 800
Vent area (cm²) 240 600 1000 1600 2200 3200 4200
Height (mm) 535 609 748 1035 1257 1750 1850
A/B Length / width (mm) 359 410 558 666 785 983 1096
Weight (kg) 38 56 75 119 171 238 312
Max. raw gas volume (m³) pro IV 1 4,4 4,4 9,7 9,7 25 25
Max. Pred (bar) 1,5 1,5 1,5 1,5 1,5 0,6 0,6

Approvals

The BRILEX IndoorVent has been tested by well-known institutions and is certified according to the (94/9/EC) ATEX 100 standard. BRILEX is certified to DIN EN ISO 9001 : 2008 Approvements and Certificates.